The answer is quite simple, it would cut into their profit margin far to deeply.īy employing the system we have perfected over more than twenty one years, you will achieve far greater sonic improvements Why does no one else in the world do it this way ? With our custom stand off and strain relief system all mess & clutter on the bottom of the tonearm are eliminated.Īnd miracle of miracles, there is no longer a connection point there. Our custom bottom end completely eliminates the original SME bottom end. We actually use almost 10 feet / 3.04 Meters of 4 X 33 to accomplish a 4.25 feet/ 1.25 Meter run of cable. No one else in the world employs two independent continuous runs of 4 X 33 fully RF shielded wire further encapsulated in an additional outer fully shielded RF jacket. We on the other hand believe that the correct solution to the problem is the more difficult and time consuming road.

Tell you that the best type of connection is no connection at all.Īll these alleged professionals are doing for you is swapping one problem for another problem. This is nothing more than the easy way out, involving the least possible amount of work & the highest possible profit.Īnyone that even knows the most basic amount about electronics & sensitive audio components will clearly Vintage SME lower four pin horizontal DIN connector with an RCA termination will solve all your problems.Īll we can say to this is, that is nonsense & pure lies. That will try to sell you on the idea that by pulling a piece of wire through the arm tube & replacing the

There are so called professional / expert SME rewiring services both here in North America & in Europe It Is Time To Take A Stand On SME Rewiring Misinformation !.

Sme tonearm connector